Fluke-biomedical MPS450 User Manual download pdf (Page 4)

Repair and calibration:

To find the nearest service center, go to www.flukebiomedical.com/service

, or

In the U.S.A.:

Cleveland Calibration Lab

Tel: 1-800-850-4606

Email: [email protected]

Everett Calibration Lab

Tel: 1-888-993-5853

Email: [email protected]

In Europe, Middle East, and Africa:

Eindhoven Calibration Lab

Tel: +31-402-675300

Email: [email protected]m

In Asia:

Everett Calibration Lab

Tel: +425-446-6945

Email: mailto:service.international@fluke.com

Certification

This instrument was thoroughly tested and inspected. It was found to meet Fluke Biomedical’s manufacturing specifications

when it was shipped from the factory. Calibration measurements are traceable to the National Institute of Standards and

Technology (NIST). Devices for which there are no NIST calibration standards are measured against in-house performance

standards using accepted test procedures.

WARNING

Unauthorized user modifications or application beyond the published specifications may result in electrical shock hazards or

improper operation. Fluke Biomedical will not be responsible for any injuries sustained due to unauthorized equipment

modifications.

Restrictions and Liabilities

Information in this document is subject to change and does not represent a commitment by Fluke Biomedical. Changes made

to the information in this document will be incorporated in new editions of the publication. No responsibility is assumed by

Fluke Biomedical for the use or reliability of software or equipment that is not supplied by Fluke Biomedical, or by its

affiliated dealers.

Manufacturing Location

The MPS450 Multiparameter Simulator is manufactured at Fluke Biomedical, 6920 Seaway Blvd., Everett, WA, U.S.A.

Applicable Testing Standards

Fluke Biomedical’s MPS450™ Multiparameter Simulator (hereafter referred to as the

MPS450) has been tested by an independent laboratory and meets the requirements listed

here.

Safety Requirements

USA UL 61010-1 (2

Edition). General requirements.

Canada CAN/CSA C22.2 No. 61010 (2

Edition), Safety

requirements for electrical equipment for measurement,

control and laboratory use.

EC Directive 2006/95/EC IEC/EN 61010-1:2001 (2

Edition), safety requirement for

electrical equipment for measurement, control, and

laboratory use.

Electromagnetic Interference and Susceptibility

EN 61326-1:2006 Emissions Class A and Immunity

FCC Class A

Warning: Changes of modifications to this unit not expressly approved by the

1 2 3 4 5 6 7 8 9 ... 125 126

Comments to this Manuals

No comments

Fluke-biomedical MPS450 User Manual Page 4

Comments to this Manuals

Related products and manuals for Equipment Fluke-biomedical MPS450