Fluke-biomedical VT305 User Manual download pdf (Page 19)

Gas Flow Analyzer

Start Up

Power Supply

The Product can be operated from the power supply or the

built-in rechargeable battery.

Use the USB cable to connect the Product to a computer

or the included power supply. The USB port is shown in

Figure 1. You can power the Product through the analog,

USB, and CAN interfaces when you use the appropriate

optional adapters.

A battery symbol shows in the display when the battery

charges. The charge level of the battery is shown in the

battery display screen. A red LED shows in the left side of

the display when the battery is low.

CAN interface

Analog

Interface

USB Port

gyo006.eps

Figure 1. Ports for Power Connection

Connect the power adapter into a mains socket with a

voltage of 100 V ac to 240 V ac at 50 Hz or 60 Hz.

 Caution

To prevent damage to the Product, make sure

the mains voltage is in the range specified on

the power adapter nameplate. Use the Product

only with the power adapter supplied with the

Product.

Filter

To prevent damage to the Product from dirt and particles

in the air, use the supplied filters for all flow

measurements. Use the filter to ensure laminar flow.

Laminar flow is necessary to make accurate flow

measurements.

Note

Particles in the air can clog the measurement

system, and cause an error message. Examine

the filter regularly.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 73 74

No comments

Fluke-biomedical VT305 User Manual Page 19