Fluke-biomedical VT305 User Manual download pdf (Page 34)

VT305

Users Manual

Measurement Data

Product measurements can be exported on the micro-SD

card, analog out interface, or the RS-232 interface.

Store Measurement Data on the Micro-SD

Card

Push and hold O for 5 seconds. This stores the

measurement data on the Micro-SD card. A message that

shows the filename that contains the measured data

shows in the display. The filename format is DataXX.csv.

See Figure 10.

There are two ways to get to the data on the Micro-SD

card. Use the USB port of the Product or put the Micro-SD

card into a computer.

To access data through the USB port, connect the USB

port of the Product to a computer.

Note

To communicate with the Product from a

computer, you must install a device driver. The

driver file “usb_cdc_ser.inf” is stored on the

Micro-SD card. Call or email technical support for

help.

When the Product senses USB communications, the

message in Figure 17 shows in this display. If you do not

make a choice in 5 seconds, the Product will not become a

USB mass storage device

Use as USB

mass storage?

YES NO

gyo063.eps

Figure 17. Mass Storage Message

When you use the Product as a USB mass storage device,

you cannot use the configuration tool to configure the

Product.

How to Connect to the Computer

Push the Micro-SD card to release it from the Product. You

can connect the Micro-SD card to your computer through a

USB port or SD-card socket. See Figure 18.

Micro-SD Card Micro-SD Card

gyo025.eps

Figure 18. Micro-SD Card

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 73 74

No comments

Fluke-biomedical VT305 User Manual Page 34